Kemper Amps Forum

I can not replicate this behaviour at all (1.0.8.7292).
Please do make a backup of your KPA and sent it together with a detailed description (including which program slot numbers you are using etc.) to our support. This way we might be able to replicate and find a possible bug.
Timo

Timo, I believe it would be helpful if you would also show up as moderator or team member, not everybody here knows who you are. Maybe add a note to your signature. For newcomers you're a beginner with a low post count, there's the risk they are going to ignore you.

Edit:...and therefore miss your advice.

Very odd. I back up one kemper and dump it on the other and havent lost a setting yet. The only goofy stuff I get in midi-i do to myself, like nuking a preset I had set-then when you press the foot controller it doesnt change-because there isnt a preset to change to, so it just stays where it is.

Quoted from "okstrat"

Here's what is happening:

Using the Kemper live with a Ground Control Pro midi footpedal. After tweaking a preset and saving it, midi 'lost' the assignment. Here are my dupe steps:

1) Load preset
2) Change reverb mix on preset
3) save preset
4) change to another preset w/midi controller
5) go back to midi preset from step 1 above, and it goes to a different preset. When I look at the midi assignments, it shows as 'unassigned'.

I was told the last time this happened to reset the midi on the kemper, but this is a pain in the ass solution. Please advise. BTW, I'm using version 1.0.8 currently, had this happen under 1.0.5 also.

Hi,
I have the same issue.
But I noticed that happend to rigs I assigned to more then one midi preset numbers.
The lowest preset number is still intact.
I am currently on version 1.0.8 beta but it happend in earlier version too.
Hope this helps in some way
// Björn

Quoted from "net99"

But I noticed that happend to rigs I assigned to more then one midi preset numbers.

Just to make it clear, KPA does not support (yet) multiple midi assignments.

Quoted from "guitarnet70"

Just to make it clear, KPA does not support (yet) multiple midi assignments.

Hm, actually it does. But indeed, that is a bug. Multiple assignments is the key to this bug. I added an issue to our bug base.
Timo

Quoted from "timo"

Quoted from "guitarnet70"

Just to make it clear, KPA does not support (yet) multiple midi assignments.

Hm, actually it does. But indeed, that is a bug. Multiple assignments is the key to this bug. I added an issue to our bug base.
Timo

You mean that it should support it but it doesn't? I was just stating what the stand is, tried it (wanted to have song based "scenes" on the midi controller) and it does not work.
I've put up a feature request a while ago for this.....how should you assign multiple program change messages to the same Rig? The menu allows you to set only one....

Ok, I found the bug. As usual in these cases, "stupid bug"
Consider it being fixed for the next release. Actually, the bug triggered a couple of other things that might been strange, like deleting a rig, but still appearing in the list (in case it was assigned twice).
To answer the question regarding multiple assignments: You could select slot #1, press assign, select slot #3 press assign again and the rig is assigned to program change 1 and 3. erasing the rig will leave 1 and 3 unassigned, changing a rig will "update" 1 and 3 (since it is just a link to the current rig). On the Browse page the MIDI number only shows the first assignment in this case ("1").
Timo