Kemper Amps Forum

How can the fcb1010 control the stomp box mode? control change?

Heho,

following problems:

1. My expression pedal for volume switch between volume on and off. between these modes i have no volume controll on the pedal. solution?

2. My Wah expression pedal works fine but when i left my foot from the pedal ist turn off the wah and come to normal mode... in every pedal position. solution?

thank you

Hi!
Anyone actually got this setup working and stable?
FCB1010, Uno chip 1.03

I've tried to follow the manuals, downloaded dump for LG-FCB Control Center and tried to set it as this:

Upper row: stomp boxes
6: Stomp A: #17
7: Stomp B: #18
8: Stomp C: #19
9: Delay: #26
10: Reverb: #28

Expression pedals:
Exp A: Volume: #7
Exp B: Wah: #1 (heel off)

Lower row: different rigs on 1-5

I have initialized the new firmware (uno) according to this:
http://www.voes.be/fcb1010/pdf/fcb1010%2…20for%20use.pdf


Calibrated the expression pedals following this procedure:
http://www.voes.be/fcb1010/pdf/fcb1010%2…on%20pedals.pdf


When I use only the Volume pedal everything works as I expected it would do.
If I try to use the Wah pedal, it works fine at first, then suddenly starts to turn on and off different stomp boxes/effects.
After that I'm not able to switch any rigs at all...

Really starting to loose my hair now

Regards
Einar

Actually I used the dump for LG-FCB Control Center since I was using a Mac.
I'll try the Ripwerx tonight from a Windows Laptop instead...

I'm lost....Downloaded the sysex opened the software I can't figure out which buttons to click on etc etc. Is there a "dummy's guide"?'

Can't get connected on LG...........Sysex in OP is Uno 1.03 and the ripwerx only works with files generated with Uno 1.02. I really suck at this.

I used this guide to program my FCB1010 with UNO chip 1.03
Everything works perfectly now.

problem was with my midi/usb cable....got a new one....all set except wah isn't working. Calibrated pedals and volume pedal works fine but wah doesn't.