I immediately hooked ti up to my mixer and M-Audio BX8 D2's and the next four hours were the quickest of my life. I've been reading the manual on line and was ready to go as soon as it arrived. First thing I did was set the Clean Sense to my American deluxe Strat. I ended up right at 6.8. Distortion is at 0. After four hours, I've only made it through the first five factory profiles. I spent the last hour and a half playing through the 9 V Crunch. I'm completely floored by the Kemper. I've read a lot of discussion on "Amp In The Room", I think it does have the amp in the room thing going on. Now, I should say, I don't crank my amps when I play. I set them loud enough to hit the sweet spot, but it's not cranked. So maybe that's got something to do with it. I've only scratched the surface, but I'm already blown away. On all the modelers I've tried, I find myself doing the same thing. I tweak, then play for 30 seconds, then tweak and play for an other 30 seconds. So in the end, I'm tweaking more than playing. With the Kemper, I'd tweak a little, then play for 20 minutes or longer. My biggest fear with this was less playing and more tweaking. I can already see this ins't going to happen.
Break times over, back to the Kemper. Expect lots of questions as I dive deeper into the Kemper.
My first questions is, I checked the FW and it's 1.8.1. are there any glitches with the latest 2. something that I should be aware of? Any thing you don't like about the latest FW?