you can place the loop either in any of the Stomps A-D in order to combine with any other stomp boxes placed between guitar and stack or in the Effects slots X or Mod. The Effects section is stereo and located behind the stack. So you can loop in stereo-effects as you would do in a studio or FOH setup, which you cannot do with a typical guitar amp mono effect loop.
There is one physical loop, which can be used for non-distorting effects (Loop Mono or Loop Stereo) or for mono distorting effects (Loop Distortion). The feature unique to Loop Distortion is that any volume boost of preceding effects will be applied to the send jack, thus driving the 'distortion pedal'.
Where is the best place to put my TC Ditto looper in the signal chain when using the Kemper? 
Where is the best place to put my TC Ditto looper in the signal chain when using the Kemper?
I'd recommend the X slot.
Thank you, I'll give that a try.
For some reason the loop volume is way lower than the channel volume, have anyone experienced anything the that?
