Threshold parameter for tuner activation on volume = 0

Andy_ · Sep 5th 2013

Hi there,

maybe it's just a problem of my controller (fcb 1010)...

It seems that the KPA does a detection for "volume = 0" but the midi controller does often not reach this value exactly. So maybe it could be very helpful to add a threshold parameter such that it would be possible to have the KPA switch to tuner (and mute the outputs) when the pedal reaches a value below this threshold.
If someone has the same problem or any workaround please leave a comment!

Regards
Andy

Ingolf · Sep 5th 2013

Firstly you should do a re- calibration of your FCB pedals.
Secondly, make sure that the range of the volume pedal (rig menu) goes down to -5.

troynova · Sep 5th 2013

I have noticed that the FCB1010 pedals seem to Drift a bit after calibration
so I set the heel setting so the pedal is not all the way down so there's extra play when I do a calibration.

Share