Should be possible to go through programmed program changes one after another in KPA by pushing just a button in KPA,
just without any outside controller. Would be very handy when setting suitable sets of sounds and trying them,
no need aways to have controller available. 
Doing midi programs changes one by one in KPA
- liulululi
- Closed
-
I'm not near my Kemper, so I can't try this, but do the direction buttons do anything in Performance mode? You could just use one of the higher-numbered Performance banks, so it doesn't interfere with the ones you use.
-
I think liulululi is asking for the possibility to sweep through the rigs he's assigned to contiguous PCs, as if he was on his MIDI pedalboard and pressed "PC Up"
-
And I suggested that Performance mode might be able to do that. He'd have to assign the rigs to performance slots, but then it would (as far as I know) work just like he wants it to.
-
Uh, OK
Now I got it. I've not tried Performance mode yet. Thanks! -
PF mode is perfect for this.
-
OK, I´ll try when I have KPA near,
havent either used performance mode yet, thanks!
