Hi,
Can I use main output XLR and TRS at the same time ? I would like to use my CLR and a couple of smaller monitors (to get stereo effect on delay and reverb)
Is it possible ?
Hi,
Can I use main output XLR and TRS at the same time ? I would like to use my CLR and a couple of smaller monitors (to get stereo effect on delay and reverb)
Is it possible ?
Yes it is
Welcome
Welcome!
What smaller ones do you use with the CLR?
Do you know that ith the options in the Master/Output menu you can even do a WDW system?
sorry Ingolf, what is a WDW system?
It is to play "at bedroom" level. What i want is coupling the CLR with a couple of behringer B2031
sorry Ingolf, what is a WDW system?
WDW stands for Wet/Dry/Wet. This is an approach where you split your signal into 3. One goes into an amp that stays dry and unaffected from FX, the other 2 carry a stereo FX signal (totally wet). The main tone (dry) stays robus and powerful this way. WDW systems were quite common in the eighties when FX quality wasn't as high as today and when the dry portion of a multi FX often compromised the basic tone.
no, I didn't know about the WDW option. According to the manual, if I want a W/D/W configuration and an effect loop, i could use the kemper as this :
- Main output (set with Reverb/Delay Wet) to my pair of behringer speakers
- monitor output (set as Mod Mix) to my Atomic CLR
- Direct output/Send and Return Input for the effect loop
Am I right ?
. Actually, I still cannot test that right nox, my kemper is backordered to 1st december ....
ouch! Wet, Dry, Wet, I see! Thanks!
Done in the past with Marshall Heads and an Ibanez Chorus
That was fun
Display Moreno, I didn't know about the WDW option. According to the manual, if I want a W/D/W configuration and an effect loop, i could use the kemper as this :
- Main output (set with Reverb/Delay Wet) to my pair of behringer speakers
- monitor output (set as Mod Mix) to my Atomic CLR
- Direct output/Send and Return Input for the effect loop
Am I right ?
. Actually, I still cannot test that right nox, my kemper is backordered to 1st december ....
Exactly. Sorry for the backorder..
New guy here, but I'm pretty sure the other main out (not the XLR) is a left and riight TS jack, not TRS as you say in your original post (in case that matters for your setup).