After upgrading to newest firmware my Midi controller isn't triggering the X slot at all. I have my patches set to CC#22 but nothing- sucks because it's my boost & have a gig soon! Did they change the CC#?
X Slot Midi problem
- badtoneno
- Closed
- Thread is marked as Resolved.
-
-
CC23 not triggering it either
-
Which MIDI controller do you use? Maybe something on the controller has been changed by you accidentaly?
-
HD500- I know my way around it decently- thx!
-
Very strange , I also use hd500 as midi controller with last firmware and it´s working fine..
Did you tried system reset on your kemper?
-
Did you check the MIDI channels on both units? They must be set to the same channel (or KPA to "omni").
-
Hmmm , If channel was wrong , nothing on midi controler would work , but here seems only X Slot Midi command is not working.
-
Hmmm , If channel was wrong , nothing on midi controler would work , but here seems only X Slot Midi command is not working.
You're right, but up to now he didn't tell us if everything else is working or not.
-
Yes everything else is working. It seems to be a very intermittent problem. One minute neither FS3 or FS4 work then they do. When they don't, I notice the foot switch isn't toggling off the stomp box on the HD500 so I'm starting to think its a hardware issue.
I gigged it NY Eve and was able to work around it but very weird. Thx!