Sorry, I meant the volume control. I can't get it to work. And also the wah now too, in system it just says that they're unplugged.
This refers to directly connected pedals, NOT pedals that are hooked up by midi like in the FCB.
Just follow the cheat sheet like I said.
It doesn't say anything about the pedals though. I have no wah and I have no volume.
Did you calibrate the pedals properly.
step by step
Are you sure you bought the Uno4Kemper firmware and not just an updated FCB1010 firmware?
When you boot the Kemper with the pedal connected, you should see a message saying "Uno for Kemper v1.0 connected." If you're not seeing that message you probably don't have this chip. With the Uno4Kemper firmware you would not use the FCB1010 instructions. You should have received the instructions with your chip but you can also find it at http://www.uno4kemper.com/UnOforKemper_manual.pdf
Hope you get it sorted.
I got it sorted. 
I had to reset the bugger! Thanks again!
IIRC the Eureka eeprom is capable of this.
Is there any way to have a full stomp box mode with no pedals forced to be rigs?
can do it with regular uno chip also just leave off program change check box turn off stomp boox mode and only use each patch for CC changes
