Just got this baby and I need a tip on output setting setup!

Switters · Mar 3rd 2014

Hello! I just bought a Kemper and I am really amazed! Just a whole different world of sound, workflow and potential!
I just need to ask if it is possible on audio and/or spdif outputs to get L---Kemper sound and R---DI.
I have my direct out hooked to a studio monitor in order to hear zero latency and feel a little better the amp sound and
I d like to record both signals.

Thank you!

Kemper Support #1 · Mar 3rd 2014

Go to the Output Source page and set the SPDIF out to GIT/STACK. That will send the DI signal on one channel of the SPDIF output and the Stack signal to the other.
Make sure to use 44,1 khz Sampling rate and set your audio interface to Sync slave.

Switters · Mar 3rd 2014

OK, thank u! Is this an option also on audio out?

Lokasenna · Mar 4th 2014

Same page, under Main Out (Master Out, maybe). The only catch is that you're stuck with which side is the amped tone and which side is DI.

viabcroce · Mar 4th 2014

Well, you can invert the cables...

Share