Tap Delay

    if we send output signal by 2 cables to the mixer, can left and right delays signals go to separate cables? Or is stereo processing only to separate overall wet and dry signals? If i can separate channels for tap delay what are the settings for this?

    you could set Monitor or Direct Out to 'Stack', or 'Master Mono' or 'Master Left' and 'Master Right' respectively and use the Main Output in the 'Delay/Reverb wet' setting.
    press and hold the button labeled 'Master', the settings are on page 1/5

    thanks Don - that was my question if for tap delay clock left and clock right can send to separate cables. Versus just separating overall delay signal from the dry signal