Normalize function - Rigs with the same volume

This has been requested several times.
But it won't happen because the only way to achieve this would be to use some compressor at the end of the signal chain, killing any dynamic potential of the profile.

My recommendation:
1. Check your clean sens.
2. Take a factory rig like the AC 30 (69) as a reference rig.
3. Level any RE rigs according to the reference.
The factory rigs are already levelled fine.

Agreed.
One of the problems is that the relationship between the perceived average loudness and the absolute maximum peak of a profile is not predictable, because strictly related to the playing technique. A clean sound will have a much lower average loudness than a distorted sound, but is able to generate much higher peaks.

One solution might be to have virtual VU meters so output level could be manually set (although I personally trust my ears).

Quote from DrB

One solution might be to have virtual VU meters so output level could be manually set (although I personally trust my ears).

... which is always the best and most sensitive method!

I still would like to have this feature...
I think, it is possible without compressor - with a given input signal, just fix the amplification to a certain value. Of course, to our ears this will not appear to be exactly the sam volume, but still this would be better than nothing.

The Kemper is already extremly good in changing the gain without changing the volume and adding FX without changing the volume - so changing the profile without changing the volume should also be possible...