Kemper v2.5 - Undo/Redo funny reports...

drumdrum · Aug 2nd 2014

Hi,

Is this normal?
Im on Kemper firmware v2.5.0.10080 according to the startup screen.

Anytime I undo or redo a volume change (as in, changing a rig volume via the volume knob (NOT the Master Volume knob)), the undo-redo display reports it as a "tag".

Likewise, if I undo/redo on a Gain change, it reports it as "Amplifier". Why is it not reported as "Gain"?

Is the redo-undo display not supposed to show the parameter that is being altered? If so, then to me its reporting is more confusing than helpful.

I would have expected its display to report back the exact parameter that was just altered.
Just wondering if it is just me, or something that others have encountered. Also like to check if it is indeed a bug, or just user-idiocy

Thanks
-DD

Raoul23 · Aug 2nd 2014

Hi Drumdrum

Can't say I've noticed this behaviour here but I'll check later and let you know my findings. I'm sure someone else will chime in by then though

Armin · Aug 3rd 2014

Yes, same here.

I would also prefer to get a display like "Amp - Gain" or "Amp - Compressor" instead of just - "Amp" - but hey its much better then before (without undo/redo).

Ingolf · Aug 3rd 2014

I agree.

Per · Aug 3rd 2014

Maybe it's storing the whole amp block's settings rather than the path to the value and the setting change? It means slightly more memory gets used but as there's already a preset system in place it's perhaps simpler to implement.

Share