Hi,
I have a problem with the overall volume of Kemper PowerHead right after startup: everything sounds to be at 10, both the power amp and the main out, even if the settings are much lower. I need to turn the master volume, and go to output settings to reset main volume to fix this every time after startup. (I have set the master volume to only impact the monitor out).
Anyone experiencing the same?
-ax
yes, sometimes I need to go to the output and turn master full down few times to make it work as usual.
I have the toaster, my problem is that it goes to: 0.0. after a litle while.
Firmware might be corrupt. Open a support ticket, but you might want to just reset the system to see if it goes away. Don't have this behaviour on my Kemper, could it be linked to an expression pedal?
To follow up: In my case, later firmware releases seem to have corrected thus, as it doesn't happen anymore.
Cheers!
