How do you mean?
Some rigs from the RE will be too loud when saved at 0 dB.
How do you mean?
Some rigs from the RE will be too loud when saved at 0 dB.
I am also playing Stratocaster. '89 Clapton and EMG DG20 PUPs. If you think your guitar way too quiet, increasing the pickup's height would help.
My Clean & Dist. Sense are -5.0 dB both. I like setting my PUPs just a little high (but not too high) because I like "meaty" tones. And my output settings are @ -6 dB on KPA and locked. I am very happy with these values at the studio or on stage.
Thank You for your suggestions about piskups. I will try that
Enjoy
I was using Fender Lace Sensors (Gold) before replacing them with EMG's and they were as close high as I desired just like Fender recommendation.
http://www.fender.com/en-TR/su…stratocaster-setup-guide/
This is from Fender's site:
PICKUPS
Set too high, pickups can cause myriad inexplicable phenomena. Depress all the strings at the last fret. Using a 6" (150 mm) ruler, measure the distance from the bottom of the first and sixth strings to the top of the pole piece. A good rule of thumb is that the distance should be greatest at the sixth-string neck pickup position, and closest at the first-string bridge pickup position. Follow the measurement guidelines in the chart below as starting points. The distance will vary according to the amount of magnetic pull from the pickup.
Bass Side Treble Side
Texas Specials 8/64" (3.2 mm) 6/64" (2.4 mm)
Vintage style 6/64" (2.4 mm) 5/64" (2 mm)
Noiseless™ Series 8/64" (3.2 mm) 6/64" (2.4 mm)
Standard Single-Coil 5/64" (2 mm) 4/64" (1.6 mm)
Humbuckers 4/64" (1.6 mm) 4/64" (1.6 mm)
Lace Sensors As close as desired (allowing for string vibration)
Some rigs from the RE will be too loud when saved at 0 dB.
and others too quiet.. another time: dear users who kindly upload rigs, please check the overall volume once your amp has been profiled
Some rigs from the RE will be too loud when saved at 0 dB.
Ah, OK... well, choose any other suiting level. My point was about having a factory rig as a reference, I was not catching it.
Ah, OK... well, choose any other suiting level. My point was about having a factory rig as a reference, I was not catching it.
Yeah, the factory rigs don't need this.
and others too quiet.. another time: dear users who kindly upload rigs, please check the overall volume once your amp has been profiled
Yes, absolutely +1.
This will not work with all rigs from the RE.
That's why I toght there could be some magic doing the trick.... Anyways trusting one's ears is allways welcome.