Disabling Cabinets

stratobobster · Nov 30th 2014

From what I have been able to determine, it doesn't look like I can get a stereo output signal without cabs, while preserving the cabs in the headphone output. Basically, I want to be able to send a stereo output signal (cabs disabled) to separate amps and cabinets on stage (right and left), while monitoring the headphone out (cabs enabled) through in ear monitors. Any suggestions or insights would be appreciated.

Thanks,
Bob

Ingolf · Nov 30th 2014

Quote from stratobobster

From what I have been able to determine, it doesn't look like I can get a stereo output signal without cabs, while preserving the cabs in the headphone output. Basically, I want to be able to send a stereo output signal (cabs disabled) to separate amps and cabinets on stage (right and left), while monitoring the headphone out (cabs enabled) through in ear monitors. Any suggestions or insights would be appreciated.
Thanks,
Bob

Welcome!
This is correct. Disabling cabs completely will also do so in HP output, Disabling only on monitor out (= Cabdriver) you'll still have cab on on direct out and the main outputs.
There is no way around it.

viabcroce · Nov 30th 2014

If the signal sent to the amps hasn't to be real stereo, you could use a split from the Monitor Out.

stratobobster · Nov 30th 2014

Thanks Ingolf and viabcroce for the info and suggestions. I may have to just break down and go FRFR one of these days, although I certainly do like the sound of my Mustang III.

Bob

viabcroce · Nov 30th 2014

Ingolf · Nov 30th 2014

Mustang III is decent but a good FRFR is definitely a step up.

Share