My PRS Navarro is a very hot guitar my CS is set to -10 and it just flashes into the red if i heavy Palm mute. I think CS is over thought sometimes just set it till it sounds good with that guitar. CK has stated that its quite hard to clip the KPA because of the soft clip feature on both input and output
I use EMGs and my clean sense is set to -12.
On my Orville-SG I'm using passive "Motown-PUs", which drive the Input-LED into totally red.
I needed to change CleanSens to -4,3 and DistSens to -3,6 to avoid input-clipping, but now the overallvolume is pretty low, so I have to create extra-Rigs for my Orville to compensate this. Additionally the sound is a bit mushy.
Are there recommendations for different solutions ?
Am I doin wrong ?
Should I ignore the Input-LED and concentrate on Output-clipping ?
Any help would be appreciated
Try lowering your PU's height.
i use EMGs also, my clean sense is 0 
just green light, not even orange maybe you are to close to the strings
just set it till it sounds good with that guitar.
again, Clean Sense does NOT influence the sound or tone. 
again, Clean Sense does NOT influence the sound or tone.
when i mentioned "sounds good" i ment the way the guitar reacts to the profiles. My bad 
On my Orville-SG I'm using passive "Motown-PUs", which drive the Input-LED into totally red.
I needed to change CleanSens to -4,3 and DistSens to -3,6 to avoid input-clipping, but now the overallvolume is pretty low, so I have to create extra-Rigs for my Orville to compensate this. Additionally the sound is a bit mushy.
Are there recommendations for different solutions ?
Am I doin wrong ?
Should I ignore the Input-LED and concentrate on Output-clipping ?
Any help would be appreciated
Dist Sens does not affect the input clipping.
Please setup Clean Sens as described in the Manual.
Thank you Kemperians,
I lowered the strings
set DS to 0 again
and set CS now below -5
Just had to compensate a little overall volume loss
Now it works 
Glad ya sorted now hurricane, enjoy
