Hey guys I thought I would let you know of an issue I have found. If you are using a ground control pro and performance mode on the kemper and the controller isn't powered up before the kemper it will not switch rigs or performances. I am not sure if this happens with other controllers as well or not.
Ground control pro issue!
- Cscism
- Thread is marked as Resolved.
-
-
Are you using the new 3.0 FW ?
-
This happened before I upgraded the firmware. I actually just updated to 3.0 and my GCP quit working all together.
-
Just downgraded back to 2.7 and my GCP works again.
-
Strange. I have Liquid Foot and it's fine on 3.0, but had GCP before that, and I used to leave my KPA on and unplug my GCP all the time, and can't recall that issue, but there have been a few FW updates since I have used GCP.