Strange things happen to me lately.. when i switch off the looper in the MOD slot (also tried it in another slot ) its off for a second, then a "click" and there's a spill over audible form the pedal im using.. (this case a Big Sky).
A 3.0 bug? connection failure? (got it mono connected and mono loop turned on/off) something I am doing wrong?? it got me baffled
Firmware 3.0 looper mal function -=solved=-
- nixxo13
- Thread is marked as Resolved.
-
-
You cannot use the looper stomp in more than one location of a rig.
-
what i ment is i tried it also in a other slot. Not in two slots at once.. the big thing for me is by deactivation the effect loop in my opinion there should not be anything be audible from the loop..or am i getting this wrong?
-
I have noticed this Also it seems the return signal is still active.
So this is good if you want delay or re-verb trails, but bad if you have noisy old analog modulation pedals.
-
I just tried it on my test setup and the signal from the external device gets muted immediately after i disengage the loop in the Profiler. When i switch it back on the effectsignal is still audible. If you hear the signal from the external device although the loop stomp is off you probably have the Aux in parameter in the output menu set to something different that 0.
-
I have checked the Output AddOns menu and all settings are on 0.0.
-
In that case please try to reset the global settings from the System menu.
-
I tried the Init global in system menu and a restarted the kemper, I still hear the sweep of my flanger pedal when the loop is off.
-
In that case please open a support ticket.
-
Solved it for me! aux in headphone was at 100% , turned it to 0 and solved.. Thanks
-
I was mistaken! was hearing the Rotary effect in the Mod slot and not the flanger in the effects loop
all is well
Thank you