What am i doing wrong when willing to change slot A from green scream to compressor ?

    Before submitting a ticket to support, I would like to get some advice first.


    I installed version 3.0.1.10908B


    I picked a rig from Rig Exchange called : 1963 Fender Tremulox w 57 mic


    It has a green scream OFF in slot A.


    I wanted to replace the green scream by a compressor .
    For that purpose, I performed a long play on "A" button and then
    using the "Type" button i changed it to "compressor" (without changing any setting for compressor).


    But now the sound is saturated, as if a part of the green scream was still active.
    (I noticed that when turning the Type button, the A slot becomes active)


    I also , started from the orginal rig, could add a compressor on stom B without getting any distortion.


    Anybody noticed such a behavior ? Is it the expected one ?


    Thanks for your feedback,

    Laurent

    Hi, i tryed it five miinutes ago with the newest software. It runs. I pushed the A Button a little longer, then i have taken the TYPE wheel and went to Compressor. I stored it in the normal way. Thats it. The compressor is 0.0, 0.0, 0.0. Please check that every parameter of the compressor is setted to 0.

    Thank your for your feedback,


    like i said, i didn't change any setting of the compressor, all 3 parameters of the displayed page are set to 0
    i'll investigate later.


    thanks again,

    Laurent