I use the KPA principle in the browser mode and I want to switch between two guitars I´m using live (one acoustic and one electric). Unlike the other parameters of the Input Stage, Input Source is global and not stored within a rig. If I put a guitar on the front input and the second on Alternate input, the front input is always active and I have to unplug this if I change the guitar. This is very uncomfortable. Surely there is a better solution for this (in Browser mode), can someone tell me this?
Thanks!
Two guitars a kemper - how do you do it? (Help needed)
- WS
- Thread is marked as Resolved.
-
-
Related feature requested by Paults here…
Feature Request: Using a Dual Footswitch to change guitars: selectable Front and Rear Inputs
-
For now, use a hardware A/B switch, before the KPA.
(I'm just like Ingolf and his Feature Requests - I forgot all about that one!)
-
I use the acoustic pre-amplified guitar plugged in the back of KPA in the Return.
Then I made some rigs for the acoustic with the Amp section off with a Loop Mono placed in the Stomp A. It works! -
A couple of options for what you're trying to do. You can't change input automatically at present, you have to go into input settings and turn a knob, so this is the best way to do it at present.
http://www.musiciansfriend.com…ector-pedal#productDetail
-
I use the acoustic pre-amplified guitar plugged in the back of KPA in the Return.
Then I made some rigs for the acoustic with the Amp section off with a Loop Mono placed in the Stomp A. It works!Thats a good idea, have to try it!
-
I think the rear input has a different impedance, though, doesn't it? Might not give the best results?
-
I think the rear input has a different impedance, though, doesn't it? Might not give the best results?
Yes, I think so. But I use it with TES (Taylor Expression System) and/or Seymour Duncan Mag Mic (both system are active) and it work perfectly!
-
Yes it's been reported by the Kemper team that the rear input is noisier though I've never checked it out myself.
-
Yes it's been reported by the Kemper team that the rear input is noisier though I've never checked it out myself.
I'm not using the Alternative Input, but the Return (of the Loop I put in the first stomp)
-
OK, impedance should not be an issue:
FRONT INPUT: 1/4 inch TS unbalanced, dynamic range >108dB, impedance 1 megohm
ALTERNATIVE INPUT: 1/4 inch TRS balanced with ground lift, dynamic range =105dB, impedance 825 kohm
RETURN: XLR balanced, 1/4 inch TRS balanced with ground lift, dynamic range =105dB, impedance 825 kohm