Hi guys, i have a little problem with my FCB 1010 (uno4kemper inside).
hen i create a rig and i set the footswitches (for example footswitch no. 6 is setted to stomp 1 in my kpa, 7 is settet to stomp 4, 8 is setted to 6) and i store it, it is working with this rig.
When i load an other rig and i set the footswitchnumbers otherwise ( 6 is kpa stomp 2, 7 is kpa stomp 4, 8 is kpa stomp 6) and i store, it is working with this rig. When i go bach to to the rig as i discribed first, the old footcontroller settings are away and the controller settings from my second example are still loaded (6 is stomp 2 and so on). Whats wrong? Normally i thougt, if i store a footcontroller configuration to one rig, it appers when i load the rig. At this time everytime the last FCB settings are still there when i change a rig and not the stered settings when i create a rig.
Problem with FCB1010
-
-
The config with the Uno4K are global, not per rig.
Only with the 'normal' UnO chip you can do rig based configuration. -
Hi Ingolf.
Shit, what about the new footboard from kpa? Can i store the configuration per rig? -
The layout ATM is this: Switches I-IIII are rig specific, pedal assignment is global.
-
So its time to change
-
-
First i look for a rcf 10" or 12", next is the footcontroler. So i think the next time when we meet my sound is ok
-
What about th EurekaProm? Does this chip based setup for the Behringer operate the same way?