Question on recording DI's

    Hi all


    Just wondering when recording the DI is there an optimum level to have the DI in at?


    Normally recording regular tracks they recommend recording fairly hot (but not clipping) but I'm noticing the DI signal quite weak in comparison


    Not sure if this would have a negative effect reamping etc?!?!


    Is there a way to control the DI out of the kemper going into the DAW?

    You should not worry about the DI signal being too low as a guitar signal is rather low in volume in general. As soon as you feed it back into the Profiler for reamping it will be fine.
    That said you can influence the level of the DI signal with the clean sens parameter in the input menu.