Hi. I am new to the Kemper having only just purchased a second hand one. The one i have bought only has about 30 profiles that the previous owner had stored in it. Is there any way i can restore the factory set profiles? I do have a dongle with about 5000 profiles on it but i wanted to start with the basic ones & work up from there. Also i intend getting a Behringer fcb1010 with a EurekaPROM2 chip as i want to use it for gigging . I have never used Midi in my life & am not even sure how you connect it up. Will i need 1 or 2 Midi cables & which input/outputs will i plug it/them into. Any help will be greatly appreciated 
standard profiles
- bigfastbike
- Thread is marked as Resolved.
-
Welcome!
Did you register your Kemper yet? This will get you into the private forum section. Also get Rig Manager and load that on your computer. It will help you manage those 5000 profiles. And yes you can get all the factory profiles in the download section of the Kemper home website.
Enjoy!!
-
Hi big,
i don't have my kpa close to me but if i remember well, from the system menu the factory rigs can be restored
-
Welcome!
Yes, you can retrieve the factory content from the system menu, and you can also download all the Kemper rig packs from the website.
At last Rig Manager helps to manage the whole lot.
-
Welcome
Rig manager is defo the way to go with things like this -
Yep. With Rig Manager it will be easy to d\l the factory content from the site and have them on your computer, and audition from there when you want, w\o having to have them installed (which would happen if you restored the factory contents from the Profiler).
-
Yup. All good advice, IMHO.
Just wanted to say welcome and congrats on the purchase, BFB!
-
With the FCB1010 you will need two midi cables. The midi out on the controller goes to the midi in on the KPA and vice versa.