Is it possible to connect a vu meter anyhow to KPA to match different profiles to same level? I`m just looking for an easy way to make different profiles volumes equal... Any other ideas?
Does it make sense to connect VU meter and how?
- aehaem
- Thread is marked as Resolved.
-
I usually use my levelmeter in Samplitude or RME Digicheck with the KPA hooked up via SPDIF to my Fireface. I'm aiming loosely for -10 dB RMS, but I'm judging the perceived loudness mostly by ear. IMHO it's the best way to watch for peaks via SPDIF because of the absolute signal level.
-
Then use Master Out or master mono configured direct or monitor out, and set it's level appropriately, for example set -20 for +4 dB devices on the Master Outputs.
-
Will try it. Thank you...
