Is it to suggest using the Kempers Return Input on the back (TRS,Line Level) to feed my Profiler with the Guitar DI for reamping?
Kemper Reamping question
- MHellerOfficial
- Thread is marked as Resolved.
-
-
No one doing this analoge?
-
I will be. Hellerman.
I didn't answer as I've forgotten the names of the inputs on the back of the unit.
At any rate, I'll be using a rear-panel input because I think the signal from our DAWs / interfaces will be too hot at +4 or even -10. Sure we could dial the level of the feeds back in our DAWs, but I'm not sure if this is valid or if the "standard" of +4 or -10 overrides this somehow in the eyes of a guitar-level input (i.e. the KPA front-panel input); it might see things differently...
You'd think I'd know this stuff as I'm an AE. Shows how long I've been out of commission, so to speak.
-
Okay haha, I have to check this way too when back to my kemper, I thought about because to avoid a Reamp Box between my DAW and the Front Input maybe.. Not sure if the Front input Noise floor is quieter in general against the Back TRS Return,
-
Im preety sure this is covered in user manual. No need to create another thread about this.
-
Sure, but not everything is explained, Damian, such as why the rear input is noisier for guitar. I think.
Point taken 'though. Mind you, if I had a dollar for every thread asking questions that're answered in the manual as well as the "quick" guides, I'd be able to afford another KPA. LOL
Heller, I'm guessing it's because the front impedance is matched for guitar, so in theory, a line-level re-amp feed from your interface to the KPA's rear shouldn't be noticeably different from the original guitar signal to the front... I think.