Good fellows...
I can't get it to clip no matter what I do...maybe an issue with the bulb?
Thanks,
Ken
Out of curiosity why do you think my INPUT LED always stays green?
- CrossHairSB
- Thread is marked as Resolved.
-
What kind of pups are you using ?
-
Hey Robman
...a set of Bare Knuckles.I make skins for the toaster and use to have to take out each LED bulb to help with alignment. I wonder if I put the wrong bulb in there.
Ken
-
You can try setting Clean sense to 12dB and playing hard + try to increase pickup height to get stronger signal from guitar. Or just use any preamp in front of KPA.
-
Was it always like this? Or did it stay green after you tested the skins?
-
Connect mater output to Return Input - put the loop(mix at 90%) in x slot (add volume to +5) - and turn master volume to the max:).
Or just connect Mater output to the input:D -
Connect mater output to Return Input - put the loop(mix at 90%) in x slot (add volume to +5) - and turn master volume to the max:).
Or just connect Mater output to the input:D
If you do this, I think the universe may collapse.
-
If you do this, I think the universe may collapse.
It will be like Large Hadron Collider -
It will be like Large Hadron Collider
Yes, exactly this was on my mind. -
Connect mater output to Return Input - put the loop(mix at 90%) in x slot (add volume to +5) - and turn master volume to the max:).
Or just connect Mater output to the input:DI'm afraid
...................lol
