I've been using SPDIF with my KPA for two years and never had any trouble. Now I can't reamp properly, and I'm at a loss as to why.
- Setting my KPA's input to SPDIF Reamp only works about half of the time, and will often stop working after I record one take. Sometimes, after a few minutes, it will sort itself back out for a take or two and then drop out again.
- When this happens, the signal out from my DAW isn't picked up, or it comes through as a few clicks and pops, and I can still play my guitar through the Kemper's front input and have the SPDIF out from that recorded in the DAW.
- Nothing's changed, hardware-wise, and I haven't unplugged any of the cables in ages.
- The only consistent fix is to reboot the KPA, which obviously gets annoying pretty quickly.
- I was running the 3.1.4 release from September when I noticed this, but I've updated to the newest one and it still happens.
- Interface is a Roland Quad-Capture running into Reaper.
Suggestions?
Edit: Now even rebooting isn't fixing it. Lovely.
Edit 2: Possibly the same issue as here: Input (is this normal?) ?