Just installed the Eurekasound v3 Eprom in my FCB1010 Footcontroller. This allows me to control the looper functions from my FCB1010 footcontroller. Unfortunately, I can't change parameters like looper position, because they are only accessible in the menu system, with the remote pedal connected. It be great if there was a switch to enable these functions, without the Kemper remote connected.
Please Allow Access To The KPA Looper Parameters Without Remote Connected
-
-
+1.
-
In fact, you can change the looper location (on page 11 in system menu) even if the menu page is grayed out.
If you still need/want the menu page NOT to be grayed out, just follow these steps:
1. press SYSTEM button
2. hold SYSTEM button for at least 3-4 seconds
3. go to page 20
4. turn TYPE encoder clockwise until item "#connected Remotes" is selected
5. turn BROWSE encoder clockwise 1 step so the value will read "1"
6. press EXIT button
7. go to SYSTEM menu page 11 = the page is not grayed out. (until next reboot)Warning: don't change anything else in debug menu