Delay mix Question

ipran · Mar 5th 2016

Hi all
im kemperize for once more
i just bought toaster powerhead, what is the best setup pair with 1x12 straight Mesa , setting output to mono or is there something else to be considered , anyway with the delay mix even I'm turning almost full but the sound of delay seem not 50/50 , am I missing something?

digbob · Mar 5th 2016

Do you use the Monitor out ?
Sounds like you use the main out, which should go to the FOH
With Monitor out to your Amp or Monitor Cab you don't have to set
anything to Mono , cause its only one output which is always mono
If you use that your Delay Mix should work

ipran · Mar 5th 2016

I just using it with cabinet only , I've plug the speaker cable to 8ohm input behind the powerhead ( the upper input) , which is there is no other cable plug to the toaster, I just handed it for 30minutes now, is there menu configuration for set output to cabinet only? Or I have to setting up first for my purpose?

thx

Ingolf · Mar 5th 2016

Set the monitor Output to Master Mono, please.

ipran · Mar 5th 2016

Quote from Ingolf

Set the monitor Output to Master Mono, please.

I've done that, but it seem it's not 50/50 even the mix is way up

fergal · Mar 5th 2016

I find I have to turn up the delay level it's on the last page of the delay parameters to make the delays pop out a bit..it doesn't seem to raise the overall signal just the delay level so maybe its another mix level?
Fergal

viabcroce · Mar 6th 2016

IIGIR, ipram is complaining they can't get the delayed signal sound as loud as the direct signal.

Ingolf · Mar 6th 2016

Quote from ipran

correct, the problems is the output to cabinet only, from headphone is just fine

In this case you need to realize that the reason for this is solely the mono mix you send to your cab vs. stereo in your headphones.
The stereo mix contains a lot more room and left/right information (or to put it better much more differentiated information).
This is obvious now, isn't it?

Share