Hi all,
I have a weird problem with the midi stuff. I already owned a GSP1101 and C2 before getting the Kemper. I love the effects in the GSP and the amps in the Kemper and the C2 floor controller is really awesome, so I would prefer to use that to control the GSP and the Kemper.
I have setup a lot of stuff on the GSP+Control2 which work fine with the Kemper, except one thing.
On the C2 there are switches 6 until 10 which control Dist, Chorus, Delay, Reverb, Control. There is a volume pedal, there is a tuner button, a tempo tap button.
Volume pedal works, tempo tap works, tuner doesn't, but heel down works as well, no so biggy. But, out of the 5 switches (6-10), three work and two do something weird, depending on the effect called on the Kemper.
I have programmed switch 6 to send cc 17, works fine, switch 7 (chorus) to send cc 24, issue. Switch 8 to send cc 27, fine. Switch 9 to send cc 29, issue.
The issue is that when cc's 24 or 29 get send the Kemper reacts, but does it inverse, so on my Control2 the light is off when the effect on the Kemper is engaged and the light is on when the effect on the Kemper is disengaged. Since the other cc's are working, I am guessing that the Control2 is sending the correct cc's. It does not matter if I toggle the status of the effects in the KPA rig beforehand.
Does anyone have similar experiences or better, a solution (other than "but a Kemper Remote", the Control 2 was VERY expensive as well).
Thanks for any assistance.
Cheers,
Michael