Has anyone screwed their remote pedal to a case or other surface?
I'm thinking of removing the rubber feet in order to secure the remote to the case using the rubber-feet screw-holes.
Not sure how deep the screws could safely go.
It should be better than velcro. Anyone done this?
Screwing your remote pedal
- slateboy
- Thread is marked as Resolved.
-
-
I've done it. I removed the rubber feet and then inserted bike chain links before replacing the feet. I've now got the Remote attached to my board, and it's rock-solid. Attached like a limpet. It's not going anywhere
-
I've removed my feet and Velcroed it to my board. I had to send my remote back for repair the other week and it was a right mission to remove it from the board the Velcro held it down bloody well.
-
Has anyone screwed their remote pedal to a case or other surface?
I'm thinking of removing the rubber feet in order to secure the remote to the case using the rubber-feet screw-holes.
Not sure how deep the screws could safely go.
It should be better than velcro. Anyone done this?i think this is the way to do it, however would recommend to keep the rubber feet at the same time. I bought small iron strips with small holes to accomplish this. See
[Blocked Image: http://s5.postimg.org/56x6z2383/Kemper.jpg]For the pedal you can use parts of bicycle chain, but they did not fit right for my remote.
-
Some wise person told me to never screw with my remote pedal
-
I've removed my feet and Velcroed it to my board
Don't do this at home, kids! -
Don't do this at home, kids!
LOL!