Hello all,
After the initial problems with my new broken Kemper, I'm glad to say I'm up and running now.
So, the other day I set about profiling some of my amp collection.
Now to my question;
My two Dumble clones have; clean channel plus a boost and then an OD channel plus boost. Obviously the clean /OD levels can be adjusted how eve you like them, and the boost is a sort of tone stack lift that gives a health level boost to either channel.
I've put all the 4 possible combinations onto a performance but noticed that all the levels are more or less the same, so when switching from clean to clean+ boost there's no level change like on the original amp, same with the OD to OD+Boost.
I've got round this by adjusting the Kemper volumes and then storing them, is this the best way to do this? Does profiling always even out volume changes?
Cheers
Marcus
