Anyone else has this? It doesn't seem to be firmware related as it has survived the last 3+ firmware updates (I'm on 4.0).
This is what happens: tweak a rig, hit "store", some time the profiler shows the next screen immediately, some times it takes a few very annoying seconds (especially if I'm editing many rigs in sequence). Then when I hit "replace", my KPA at times takes as long as 5 seconds to show the "stored" (unnecessary, IMHO) pop-up message. Some times it shows after or during the change to the next rig because it takes so long, if I'm distracted I end up not even noticing the confirmation message never came up.
So is my Kemper defective or do I need to perform some serious kind of global reset on it?