Here are the glitches and bugs i have found after 5 hours of digging:
1. After saving a rig on perform mode there is a very minor digital "pop" and during that "pop", all effects trails are getting cut off.
2. Latency on remote....It take time for the remote to switch between rigs in perform mode (all though the sound itself has no latency)
3. Kpa Loading time from start is much much longer then then 3.3.0 fw .... 1 min & 13 sec' to be exact (don't know if it's an issue, it would be nicer if it will up load a bit quicker ...)
4. On switch number 2 on the remote ,the upper led doesn't show that there is a morph parameter "on board" (only the lower led....)
5. When changing between "banks" there is that " digital pop" sound...
(Like in paragraph no' 1 ....)
Here are the bugs and gliches i found after four hours of digging in the kemper with the new 4.0.3 fm
-
-
to 3.: Less rigs in your KPA and your memory load them faster.
-
Here are the glitches and bugs i have found after 5 hours of digging:
1. After saving a rig on perform mode there is a very minor digital "pop" and during that "pop", all effects trails are getting cut off.
2. Latency on remote....It take time for the remote to switch between rigs in perform mode (all though the sound itself has no latency)
3. Kpa Loading time from start is much much longer then then 3.3.0 fw .... 1 min & 13 sec' to be exact (don't know if it's an issue, it would be nicer if it will up load a bit quicker ...)
4. On switch number 2 on the remote ,the upper led doesn't show that there is a morph parameter "on board" (only the lower led....)
5. When changing between "banks" there is that " digital pop" sound...
(Like in paragraph no' 1 ....)to Nr. 1:
this is the same in 4.0.2 !!! -
4. On switch number 2 on the remote ,the upper led doesn't show that there is a morph parameter "on board" (only the lower led....)
I can not confirm.
My Kemper shows that morph parameters are stored, when the rig is active. (all Slots) -
Guys - I don't wanna sound smartass(ish), but there are threads with pages of discussion about the beta 4 firmware in the "fitting" subforums.
@noamb2604 please have this thread moved/merged by the mods.
-
I have heard that digital pop sound and plan on recording it and opening a ticket once I have some time to spend.
-
About #4: might it be a hardware issue?