Help needed!
I recently tried to plug my pedalboard in the fx loop of the kemper. I chose the stereo signal return (return + alternative input) to use my h9 and blue sky as a stereo pedal. Unfortunately I couldn't figure out why there is no sound at all.
Actually I hear noise when I press the compressor or an OD in my pedalboard, furthermore I hear the typical plug noise when I plug the cable in and out. So the return of the kemper obviously does work.
I used to Stereo Loop in the X Slot. If I turn down the Mix-Knob I hear the guitar sounding, but of course only the direct signal. So the cables work as well.Is my kemper unit broken somehow? Any suggestions I haven't tried yet? Maybe there's a global setting I missed?
Thanks so much, folks!
Help needed! Stereo FX Loop!
- FelixGerlach
- Thread is marked as Resolved.
-
How is the loop level set?
-
The loop level is set to 0dB, the mix is 100%.
Ok, just to exclude a malfunction of the profiler's loop:
How does it sound if you put a TS cable between send and return? -
If I do so it's dead, at least if I turn the "mix" up to 100%. I begin to think the send is broken. The return seems to react on the things I press on the pedalboard, and the tuner located at the first position on the board actually doesn't get any signal in!
-
Do you have the AUX in level turned to zero? I think it's in the system settings.
-
Silly question. Do you have Direct Output set to Stack and Direct Volume ok?
