Problems profiling a bass amp

  • Did a test. Profiled a cable between direct out and return and the profile and the cable sound :D are spot on!


    Isn't a cable problem because, when comparing, I'm sending both signals to the Kemper and comparing from it's outputs so I'm comparing the Kemper profile with the signal that enter into the Kemper through the same cables I used to profile.

    Edited 2 times, last by pacocito ().

  • One more test. Profiled the chain including the UA Apollo with no plugins and it was profiled perfectly. Then added the amp matching the levels, no peaks anywhere and no matter how much I refine, there is a big difference in the lows.


    How do you refine with a bass?