Arrangig Performances with new RM: Swap instead of Move?

BobbyKa · Oct 6th 2016

Yesterday I tried to arrange the Performances in a Kemper connected to RM.
Lets say I got 3 perfomances "P1", "P2", P3". If i grab P3 and want to move it before P1, the new RM doesn't move P3 (so I'd have "P3", P1", "P2") but does swap them (so I get the new order "P3", "P2", "P1").

Is this a bug or did you change this behaviour purposely?

If you got only 3 performances this is of course no problem, also because with right click you can chose "move up" or "move down".
But if you got a lot of performances and want to arrange them according to the setlist of a gig this is very impractical

whippinpost91850 · Oct 7th 2016

Man I couldn't agree more. Thanks for bringing this up

Arne · Oct 7th 2016

Did you switch from Mac to PC? On Mac it is a move, on PC it's a swap. It has been the same way in V1.5.

Nightwish2 · Oct 11th 2016

Then it should have been corrected back then. It should not be any difference imho..

LH · Oct 11th 2016

I agree!
I don't know how hard/impossible it is to change this behavior, but for me it would make much more sense to move the Performances instead of swap.

If you have 50 Performances and you want to put P50 between P5 and P6, you will end up with P50 after P5 and P6 after P49.
It takes quite some time to arrange this correctly then.

Share