hi
the screw type is called torx
you can find drivers for this easily
in every building store
I've used furniture sliders like below, for former amp heads for this. Come in different thicknesses, just place em under the existing feet for added height, no need to mess/alter with the KPA.
How would you attach them under the existing feet, @cybermgk? Would you glue them or just place the Kemper over them without permanent attachment?
Just place them under the KPAs feet (or any amp). If your Gigging it, and need it regularly, while moving around, I'd use that spray adhesive. It isn't permanent, but will hold them on pretty good.
Bigfoot Kemper!
Oh yeah!
Wuddun, Chris; looks great man!
@chopsfromhell where did you source the necessary parts?
You could also use slip on rubber chair or bar stool tips, to make the KPA feet taller. They can be found at your local hardware store.
Hello everyone,
I am wanting to replace the rubber feet on my Kemper with bigger ones so that I can put it on top of my Line 6 DT25 cab and clear the cab's handle. Anyone have the specs for the screws holding the stock feet on? I'm sure I will need longer screws for the new rubber feet. Metric I would assume? I also need to find a tool just to take the feet off. Anyone replaced the feet on their Kemper already?
Thanks in advance!
Hey --- I just went through and replaced the four rubber feet on my Kemper with taller ones to clear the handle on my Mesa cab. I ordered these 1" tall feet from Amazon for $8:
https://www.amazon.com/gp/prod…age_o09_s00?ie=UTF8&psc=1
[Blocked Image: https://images-na.ssl-images-amazon.com/images/I/717a582V96L._SL1500_.jpg]
You'll need new, taller screws in order to attach these. The existing ones are Torx, requiring a special driver to remove, but not a big deal. You can get new screws from a hardware store. I believe the screw size is M4 - 0.7, but don't recall exactly. I think I got some that were 3/4" long or so. Most hardware stores have a display where you can test a screw you bring to figure out its exact thread and diameter size. The important thing though is that it's a metric thread size. Works perfect and looks like it was made for it!
Great idea!
Already purchased and received a replacement set of rubber feet that go with the DT25 cabs which I am going to try to put on the Kemper, and just got a Torx driver for the screws so I'm going to give it a go. Got a Camplifier 290 on the way so I needed the Torx driver anyway...
Chopsfromhell - I know this thread is old, but did you need to replace the stock screws on the existing Kemper rubber feet when you installed the new set from Line6 Spider Valve feet?
Perfect. Thanks for the update. I will be getting new rubber feet via th USPS today and I will be heading to hardware store to get new screws. I will do the same as you and measure length of screw that sticks out of old feet in order to not go too far into Kemper.
