Pedal Vinyl Stop; bypass at heel (Edit: Never mind)

I was just fiddling around with the Vinyl Stop effect, which is awesome, and I realized that it's active even in the heel position - the signal is still being dropped about a quarter step.

Could it perhaps fade out the effect as the pedal goes to 0?

Alternatively, I noticed there are a few existing FRs to expand the options for this stomp. How about just adding...

Heel (0 to 10)
Toe (0 to 10)

?

With a value of 0, the effect could internally set the Mix to 0%. A value of 0.1 would start where the current Heel position is.

Cheers.

Edit: My pedal was just acting up, I guess. I had tried restarting everything several times, recalibrating, and it still had trouble, but now (a few hours later) everything's hunky dory.

Quote from Robrecht

I think your pedal might need calibrating. With the pedal at zero, I get correct pitch.

I think maybe the KPA's being inconsistent then. Using Wah effects with "Bypass@Heel" works fine, and it turns on the tuner just fine at 0.

Edit: Alright, it was the pedal apparently. I had tried restarting and recalibrating earlier, still had the issue, but now - several hours later - it's gone. Oh well.