Include FX On/Off states in the Morph function?

bagginz · Dec 3rd 2016

Like many people I often set up two versions of sounds on each switch of the Remote - a clean rhythm for chords and a lead sound for single note lines - typically with more gain and volume - so I can toggle between them with just one switch. (I prefer to stay inside one Performance of 5 rigs for shows)

It would be *most* useful to be able to simultaneously toggle the the Delay on (or Distortion, Autowah - whatever) for the lead sound when switching between the morph states ( while turning the Chorus off for the chord sound)

Would help keep the stage tap dancing to a minimum.

paults · Dec 3rd 2016

You can do this now by Morphing the Mix control of each effect.

bagginz · Dec 4th 2016

Quote from paults

You can do this now by Morphing the Mix control of each effect.

That's a useful work around. Thanks!

Darren0071 · Oct 30th 2017

Thats ok to alter mix levels via morphing with some effects, but if you want to morph between two delays setting (different delay settings in two separate effects blocks) you loose the rails of the longer delays when morphing between the two. For these reasons (unless someone has a better work around) is why I would prefer to morph effects ON/OFF instead of mearly adjusting the mix of each.

ckemper · Dec 5th 2017

When you set the Delay Mix to "Pre" instead of "Post", then the delay tails are not cut when the mix is morphed.

Darren0071 · Dec 12th 2017

Good point ckemper. I just tried that and is perfect!

Share