Hi all,
I've profiled and posted to Rig Exchange 8 Studio profiles of my Ceriatone Yeti 50. If you are not familiar with this head it is essentially a modded plexi design that can take you into very hot plexi territory, further there is a mode switch that invokes a Jose diode clipping circuit.
I profiled the amp running into my THD 2x12 which is loaded with Warehouse Veteran 30 speakers, with an SM57 mic.
A Kemper owning mate of mine tried these out over the last few days and gave them the thumbs up, so I decided to post for all to enjoy.
The profiles are:
Yeti 50 Clean - single gain stage only, clean and full plexi.
Yeti 50 w/ bright - same as above but with bright switch engaged, effectively a HPF that allows the top end to break up. Works quite well with a boost stomp in front.
Yeti 50 Med - ok into gain territory now, both gain stages in. This is medium gain at noon with bright switches set on.
Yeti 50 Med+KokoMid - same as above but with the Suhr KokoBoost in mid boost mode in front of the amp.
Yeti 50 Max - Like the Med profile but with gain 1 all the way to 11. (yep, it goes to 11!)
Yeti 50 Max+Koko - same as the Max profile but with the Suhr KokoBoost in front
Yeti 50 Max+KokoMid - same as the Max profile but with the Suhr KokoBoost in mid boost mode in front.
Yeti 50 '80's mode - gain 1 back to noon, with bright switch set and the Jose diode circuit in
If you like a gained up plexi then hopefully you find something here you like.
