Tuner after Start - SOLVED

Do you have a pedalboard connected?

Check the tuner parameter in system menue

Did it solve your problem?

Quote from Hurricane

Nope !There's no soft button or anything else in the system-menu to switch on or off.

Yes, sorry it isnt. What are your settings in tuner menue?Mine are mute tuner is setted and Tuner volume 0n is setted.

Same Problem here.

Maybe its time for a support ticket

Is your issue that the tuner mode shows up briefly after the startup screen before it goes into whatever other mode is selected?

Quote from Hurricane

Doesn't your Profiler start with Tuner-Mode on ?

I start my kpa in browser or performance mode and the tuner is not shown. Tuner appears only when my volume pedal is off.

Is it your expression pedal (volume) right down so going into tuner mode?

Quote from Hurricane

No, it stays constantly in tuner mode. Even when switching to f.e. performance mode and back again or to tuner-mode (via Hardware-knob) and back again.
After "switching off" the tuner via my Mission-Expression-Pedal , which is linked to the Remote, all is as usual.
It occurs just only after starting the Profiler.

In that case please send an email to [email protected]

Quote from Hurricane

I'll send you my Last Backup, thanks

Interesting. Keep us informed.

I think I have the same problem:

OS 5.1.1
Remote connected.
On pedal 4 connector of the remote: stereo cable with ring to switch the Looper Mode and tip to switch Tuner.
The 2 switches are normally open.

Polarity of Looper Switch: reverse polarity (otherwise I start in Looper mode...)
Polarity of Tuner Switch: normal polarity (when I choose reverse polarity: the switch doesn't work at all...)

When I start up the Kemper, it's shows for 5 seconds the normal performance but then the Tuner appears. When with I switch off the Tuner, everything works normal.