Fender Frontman 212R

  • Yesterday I use for first time my new Fender Frontman to monitor my Kemper in a live gig. My first attempt was to use monitor output on the Kemper to power amp in the Amp, because I dont want the coloration of the normal input of the amp, but the power amp looks dont have enought sensivility for the monitor output of the Kemper, and I have to set it to max volume, and still would need a little more volume. There is some setting in kemper to up the monitor signal? (like the -12 db for the normal output setting).


    My workaround was to plug the kemper in normal input of the amp, and playing a little with the EQ, not bad sound, but I would prefer to use the power amp input. If the kemper can not give more level on monitor, I will try to modify the power amp input of the Amp, by lower the first resistor of the amp's input.
    Some advice to up the monitor output level?


    Thank you in advance

  • I see the specs for the Fender Frontman 212R and in the the power amp input I can see this:


    POWER AMP INPUT:
    IMPEDANCE: 10KΩ
    SENSITIVITY: 930mV for 100W into 4Ω @ 1 kHz


    Anyone knows the output of the Kemper in mV?