I'm struggling to figure out how to use my Kemper Power Profiler to run my two marshal cabinets I want to run as a "stack". The cabinet output only has one jack and so do the cabinets so I am scratching my head on how to do this. I know this can't be a new issue....probably a NEWB issue. Help me out folks.
Using Power Amp to fuel two marshal cabinets....
- biskitzngravy
- Thread is marked as Resolved.
-
-
Assuming they are 16 ohm cabinets, You need a "Y" speaker cable (also known as a parallel cable). Be sure it is a speaker cable, not a line cable.
-
I have one of these, they are very well made and do the trick.
-
I use this! Works, and the diagram on top of the box is very handy! (the Kemper runs @ 8ohm 600 watts or 16ohm @ 300watts) I'm using 1, 8ohm 2x12 cab with the kemper running at 600 watts. When i split the signal I can do 2, 16ohm cabs in parallel Or 2, 8ohm cabs in series. Or 2, 4ohm cabs in series.
https://www.thomann.de/nl/palm…_rslt_cab+split_314812_29
Running the poweramp full on gives me just about enough volume to compete with my drummer (using 2 cabs)