Is it possible to assign the effects loop to one of the stomp slots (ABCD) in front of the amp. I have a maxon OD808x that I want to pull in and out of the signal chain. I know there is one built into the kemper but I like this pedal a little more.
Effects Loop assign to stomp in front of amp
- spazmatron
- Thread is marked as Resolved.
-
-
Yes quite easy. Same as any effect you can assign it to A,B,C or D and choose between mono or stereo and even Clean or Distortion
-
Ill look into the manual more but what do you mean by set it up as clean or distorted? I want it to go before it hits the amp for my distorted profiles and leave it out for my clean profiles.
-
There is a loop setting for using a distortion device (pedal, Preamp etc) there is another one for delay mods etc. Best to read the manual