I have a question for those that link 2 Atomic CLRs together. When I hook them together the XLR linked 2nd CLR is much louder. I have to set the 2nd CLR master to about halfway to be equal volume to the first CLR. Is this normal or should they both be the same volume when linked? I switched both CLRs and cables but that did not seem to help. I set the 1st CLR to "send out 1" because 1 is the only input used on the first CLR. If I hook both CLRs up using separate outputs on the Kemper than both the CLRs are the same volume.
Question for those that link 2 Atomic CLRs To Kemper
- BILLIAM666
- Thread is marked as Resolved.
-
-
Nobody linking 2 CLRs?
-
I believe that @Ingolf has played with this configuration, no? There used to be a user on here called @viabcroce that had two CLRs too, I believe, or maybe I've got my wires crossed...?
-
I believe that @Ingolf has played with this configuration, no? There used to be a user on here called @viabcroce that had two CLRs too, I believe, or maybe I've got my wires crossed...?
No, I had never configurated my CLR's this way.
-
No, I had never configurated my CLR's this way.
Oh, hahaha! Sorry, Ingolf, was sure you had!
-
Linking two means both carry the same signal?
Mono, not stereo? -
Isn't it so that you can link a second one from one clr but the second one must be a non powered monitor? Cant believe that its ok when you link another powered frfr to to first one.
-
In my rcf 10" sma frfr there is an xlr out for a daisy chain to an other speaker, but in the manual is no description that it has to be another powered speaker. I think it has to be an unpowered one.
-
I could be wrong, But I believe my directions said, the link is a input link for another powered cabinet
-
Yes it is for another powered speaker. It is mono or stereo. If you plug two stereo inputs to the 1st CLR, set it to send out 1 or 2, then link via an XLR than it is stereo and sounds fuller than one cable to each CLR. When using 1 CLR it sounds better to have 2 cables both CLR channels.