How to use effect buttions on remote to change delay-mix

MetalMauce · Aug 3rd 2017

Hi,

I've set one effect button on the remote to switch between 2 EQ's in slow MOD and X but I want to add a third for delay.
However, I don't want to switch delay on or off but I want to swittch between two mix values for delay so that effect button switchs as follows:

Engaged: EQ1=off, EQ2=on, DELAYMIX=percentage1
Disengaged EQ1=on, EQ2=off, DELAYMIX=percentage2

So, I managed alternating switching between EQ1 and EQ2 but I don't know how to switch between two mix values for the delay.

Anybody knows how to achieve this?

Thanks in advance.

Ingolf · Aug 3rd 2017

Read up on morphing.
This will get you what you want.

MetalMauce · Aug 4th 2017

Thank you for your reply.
I played with morphing and that will do the delay-mix thing
However, I couldn't manage to switch the EQ's with morphing.

This means I need to push two swithces (1xeffect button for EQs and 1x morph).

Is there a way to get it in 1 switch?

Laurens · Aug 4th 2017

Morph both the EQ and the delay at the same time.
So you just set EQ and delay for position 1 and then set them again for position 2.

You could also have both EQ's active and morph the Mix on both if you find that easier.

ReneLangenhan · Aug 4th 2017

OR you could load two delays into the Mod and Delay blocks and alternate between them with the same fx button.
You could do the same thing with two EQ stomps, even assigned to the same button if you need it along with the delay change.

For the Stack section EQ morphing is definitely the best approach IMHO.

Share