The Rigs are switching correctly in Performance mode. When I assign them numbers in Browser mode I can see the numbers in the lower screen however the corresponding switch does not bring the rig up. I have arrowed all the way up and all the way down and tried it with no luck. It recognizes the current rig under system settings and the current assigned rig but the buttons are not initiating the correct rigs. Any ideas to try?
Rig Switching in Browse Mode
- bshaw92
- Thread is marked as Resolved.
-
Rig switching in Browse Mode responds to MIDI PC from a MIDI controller, not if you using The Remote.
The Remote use's your selected "View" filters on the KPA to switch through the Rigs.
One easy way to organize Browse Mode Rigs is to use Rig Manager to add 001, 002, etc. to the beginning of the Rig names that you want to be recalled with The Remote in Browse Mode.
-
Thanks. I was trying to remember how I did it before and thought I might be going a little crazy.
If it is any consolation, I had to check in the Reference Manual to be sure I was going to give you an accurate answer.
