Input level for profiling?

  • This may be a question I should already know the answer too but... is there an input meter for the profiling process? If so where is it? If not, how do you set a level going into the profile? I'm going to profile a few amps this weekend and would love to get it right. ;)


    I'm sure it's simple. Am I missing something?


    Thanks,


    Steve

  • The output (!!!) LED acts as meter to not clip the A/D converter while profiling. Use the Return Level to adjust the incoming signal. Best Practice is to choose a similar rig before profiling, and comparing the rig with the amp you are going to profile. Adjust the return level in a way that both signals habe nearly the same volume.